Category Archives: SatPC32

Some “flakiness” tracking FO-118 with SatPC32

Posted on January 22, 2023 by robert

I’ve been having fun with FO-118 for the past week, trying to get used to it’s unique strangeness (drifting signals).  But I’ve run into issues where my IC-9700 seems to stop updating for Doppler; both uplink and downlink.  I was … Continue reading →

Posted in IC-9700, SatPC32 | Leave a comment

ISS Cross Band Repeater QSO

Posted on December 19, 2022 by robert

While I’ve worked the ISS using their original cross band repeater a few times in the past, I don’t recall if I’ve worked it using the new gear on 145.990 (PL 67.0) / 437.800  (V/U). Thanks to Magicalmike KO4PDI for … Continue reading →

Posted in ISS, Satellite, SatPC32 | 4 Comments

Back on the birds!

Posted on June 7, 2022 by robert

I’ve been using an ancient Panasonic ToughBook (CF-31) as the computer to control my IC-9700 for satellite work.  I liked the TB because the screen is readable in full daylight.  That particular computer was never fully supported by Panasonic to … Continue reading →

Posted in AMSAT, AO-7, AO-73, CAS-4A, CAS-4B, CF31, Satellite, SatPC32, SO-50, Toughbook, XW-2C | Leave a comment

IC-9700 Upgrade clears CI-V USB Echo Back

Posted on June 22, 2021 by Bob Beatty

Although I didn’t mention it yesterday, in the process of upgrading my IC-9700 firmware to version 1.30 (in an attempt to get Winlink TX audio working – nothing to do with satellites), it unknowingly cleared the CI-V USB Echo Back … Continue reading →

Posted in AO-91, IC-9700, SatPC32, XW-2A | Leave a comment

Some Tweaking for HuskySat-1

Posted on February 4, 2020 by Bob Beatty

Despite having the specified 435799.7 KHz frequency at the satellite for the Beacon Downlink in my Doppler.SQF file, I still wasn’t able to automatically decode the satellite telemetry using FoxTelem. I did a bit of thinking, and am guessing that … Continue reading →

Posted in FoxTelem, HuskySat-1, IC-9700, SatPC32 | Leave a comment

Configuring SatPC32 for an Icom IC-9700

Posted on February 3, 2020 by Bob Beatty

After ensuring that the latest Icom USB drivers have been installed (before plugging the radio into the computer), the following are the basic steps for configuring the radio and a new installation of SatPC32: On the 9700 – Menu/Set/Connectors/CI-V.  As … Continue reading →

Posted in AMSAT, HuskySat-1, IC-9700, SatPC32 | 2 Comments

First Decodes of HuskySat-1

Posted on February 3, 2020 by Bob Beatty

A new satellite, HuskySat-1, was launched this past Friday, from a departing Cygnus Supply Vehicle.  After leaving the ISS, the Cygnus was boosted into a higher orbit, then the 3U HuskySat-1 was launched.  Basic details are: HuskySat-1 ———- Uplink:    … Continue reading →

Posted in AMSAT, FoxTelem, HuskySat-1, IC-9700, SatPC32 | 2 Comments