Monthly Archives: October 2026

Finally Chasing SOTA (Thanks Thomas!)

I’ve been aware of SOTA for ages, but since mountain-topping isn’t in my DNA, I never bothered to create an account.  Recently my POTA-pal K4SWL has done some SOTA activations, and I’ve worked him, marveling at his S9 signal strength … Continue reading →

Posted in SOTA | Leave a comment

Using a <$30 HT to send true CW on 2m

I ordered a QuanSheng UV-5R v3 from Amazon, with the intent of uploading NR7Y’s CW firmware.  The reason for that particular firmware is that it supports attaching a paddle to the radio via a USB-C cable, and does NOT require … Continue reading →

Posted in 2-Meters, Brass Knuckle Gang, CW, From the OM, Morse Code | Leave a comment

Did a Common Mode Current Choke Help?

I did before and after testing using the big coax choke from COMTEK, and it did not help.  The noise I was seeing on the 40 and 15-meter bands was still there and at the same level. Unfortunately I was … Continue reading →

Posted in From the OM | Leave a comment

COM-CFC-50A Choke Test

I have a couple of other Common Mode Current Chokes laying around the shack.  One of them is the COMTEK COM-CFC-50A.  It’s a beefy choke, rated at 5KW – about 6 feet long and covered with 75 ferrite beads over … Continue reading →

Posted in From the OM | Leave a comment

PackTenna CMC Test Results

Using the Halibut Electronics CMC Test Rig, I hooked up the PackTenna PAK-103 In-Line Common Mode Choke (rated for 100 watts).  The nanoVNA was calibrated using the Open/Short/Load on the Test Fixture. Here are the results with some markers on … Continue reading →

Posted in From the OM, Testing | Leave a comment

Common Mode Choke Test Rig

Having been in the hobby for more than a few decades, various issues with RFI in the shack are often attributed to “common mode current” – that is a signal that is injected into our coax in such a way … Continue reading →

Posted in Testing | Leave a comment