Category Archives: Satellite

Just Completed Oscar Satellite Communications Achievement Award

Posted on July 27, 2016 by robert

The QSL rate for satellite operators is disappointingly low, even for those using LotW.  This means it takes more time to obtain various operating awards. Today, I finally qualified for the AMSAT Oscar Satellite Communications Achievement Award, which is 20 different … Continue reading →

Posted in AMSAT, Satellite | Leave a comment

UKube-1 Downlink 1 KHz High?

Posted on June 20, 2016 by robert

For the third day in a row I’ve been monitoring the FUNcube-2/UKube-1 telemetry downlink, and have determined for a detected tone frequency of 1500 Hz according to the Funcube Dashboard software, I need to set the Downlink frequency to 145.916 KHz.  This … Continue reading →

Posted in Satellite, UKUBE-1 | Leave a comment

First UKube-1 QSO

Posted on June 18, 2016 by robert

Paul, N8HM (FM18), who posted the message about FUNcube-2/UKube-1 being active, happened to be my first SSB QSO at 17:18 UTC today. My TX offset was 14.3 KHz higher than specified, but for this first time, at least, things seemed … Continue reading →

Posted in Satellite, UKUBE-1 | Leave a comment

Yet Another New Satellite – UKube-1

Posted on June 18, 2016 by robert

I noticed a day or two ago that the UKube-1 transponder had been turned on.  I believe it is going to be left in that mode full-time.  I finally had a chance to capture a telemetry frame today during a … Continue reading →

Posted in Satellite, UKUBE-1 | Leave a comment

Field Day 2016 Satellite Passes for FN41

Posted on June 15, 2016 by robert

The table of times listed below will likely be off a bit since FD is about 10 days in the future and the TLEs will have changed slightly by then.  However it is good enough for planning purposes.  Daylight and … Continue reading →

Posted in AO-7, AO-73, AO-85, FO-29, Satellite, SO-50, XW-2A, XW-2C, XW-2F | Leave a comment

Back to AO-73 Dashboard for a Bit

Posted on June 7, 2016 by robert

The SatGate appears to be working fine, and it seems to find more unique packets than duplicate ones, so it appears to work.  Ultimately I want to package that up with a RPi running XASTIR using a TNC-Pi and a … Continue reading →

Posted in AO-73, Satellite | Leave a comment

SatGate Worked!

Posted on May 31, 2016 by robert

SatGate worked after I made changes to the SatGate2/IGate Settings tab, changing the “Gate only these” list to be RS0ISS*.  (That did not allow PSAT-1 to route through as you might expect — see below). Immediately after a pass of … Continue reading →

Posted in APRS, ISS, Packet, Satellite | Leave a comment

Where Did the SatGate2 RF->Internet Packets Go?

Posted on May 31, 2016 by robert

I had UISS, CAT7200, and SatGate2 running last night.  My hourly beacon was showing up just fine on the APRS network, but I was disappointing that nothing appeared to get routed from the RF side to the Internet. When I … Continue reading →

Posted in APRS, ARISS, ISS, Packet, Satellite | Leave a comment

Getting SatGate 2 to run Under Win 10 32-bit

Posted on May 30, 2016 by robert

I think I used my quota of good luck up getting UISS and CAT7200 running on my Win10 laptop.  That laptop had a fresh install of Win10 32-bit on it, so it had no legacy files from prior Windows versions. … Continue reading →

Posted in APRS, ARISS, Digital Mode, IC-9100, Packet, Satellite | Leave a comment

Setup UZ7HO’s SoundModem

Posted on May 30, 2016 by robert

UZ7HO’s SoundModem program is automatically installed when you install UISS.  It’s a program that converts the audio tones sent/received into AX.25 data that can be understood by UISS.  To use SoundModem requires a few simple setup steps. When you first … Continue reading →

Posted in APRS, ARISS, Digital Mode, ISS, Packet, Satellite | 4 Comments