Correct Setup to Use a IC-9100 with WSJT-X

WSJTX Radio Settings

Bookmark the permalink.

2 Responses to WSJTX Radio Settings

  1. Rick Lawn says:

    I cannot get this to work. As soon as I begin to tune the radio I get this error message –
    Hamlib error Communications bus collision while getting PTT state. Any advise?
    73
    Rick, W2JAZ

  2. robert says:

    Unfortunately I do not. But from the error message it almost seems like something else is attempting to communicate with the radio at the same time. Only WSJT-X can be controlling the radio. Also make sure that PTT control is set to CAT.

    Be sure you have the latest version of WSJT-X — that’s working just fine with my IC-9100.

Leave a Reply

Your email address will not be published. Required fields are marked *